HCFK series intelligent electronic capacitor switching switches are new-generation electronic products (hereinafter referred to as composite switches, which are divided into co-compensation type and sub-complement type. Co-compensation type is used for switching three-phase capacitors, using 4 connection method; The complementary type is used for switching single-phase capacitors, and uses a V-type connection. The advantages of the new-generation composite switch use single-chip technology, which is a combination of software and hardware. According to the phase sequence characteristics of three-phase electricity, it works in several AC cycles during operation. According to the phase of each phase, the single-chip microcomputer is used to switch each phase of the capacitor, so as to realize the switching process of the parallel capacitor without inrush current and without overvoltage. The composite switch has no impact, low power consumption, long life, low failure With obvious advantages, it can replace AC contactors and capacitive contactless switches, and is widely used in the field of low-voltage reactive power compensation.

Conditions of Use

1. The altitude does not exceed 2500 meters.
2. Ambient temperature 25 * C + 50C.
3. The air humidity does not exceed 50% at 40 ^ C and 90% at 20 ° C.
4. There is no corrosive gas, conductive dust, flammable and explosive media in the surrounding environment,
5. There is no severe vibration at the installation site.

Technical Parameters

■ Rated working voltage 380V, 220V / AC 20%
■ Dimension 160mm 96mm 90mm
■ External rated frequency 50Hz 0.5
■ Working power 220V
■ Every turn-on and turn-off interval ≥ 1 second
■ Circuit power consumption s1.5VA
■ Service life 100,000 times
■ Interval between two consecutive connection ≥30 seconds Note: When the switch is off
■ Contact voltage ≥1600V
■ Control capacity (three-phase ≤30KVar; type connection)
30 seconds delay (default) after turning on again
■ On impedance 20.0030
(Single phase s10KVar; Y connection)
■ Insulation grade: ≥10M under normal atmospheric conditions
■ Fixed size 142mm 80mm
■ Contact voltage drop≤100mV
■ Control voltage: DC8-18V
■ Corresponding time s1000ms
■ Voltage distortion rate s 5%

Features

1. Voltage zero-crossing. The zero-crossing current is cut off, there is no current flow, and no overvoltage is generated.
2. Low power consumption and no generated waves.
3. Input signal, away from EMC protection measures, strong anti-interference ability
4. It can be directly used with this company's dynamic reactive power compensation control system.
5. The running state of the switch is divided into time, phase and delay. Electric Ba indicator function.

Model Meaning

Wiring diagram